Shimano Disc Brake SLX M7100 J-Kit - 1700mm

SHIMANO SLX M7100 DISC BRAKE J-KIT - 1700mm

The SHIMANO SLX M7100 brake kit features the SERVO-WAVE system, offering outstanding and reliable performance while maintaining smooth operation. It includes a refined, ergonomic 2-finger lever that allows for precise braking control. The master cylinder and dual-piston caliper ensure powerful and dependable braking in all conditions. The M7100 lever also features an additional support point on the handlebar to enhance rigidity during braking.

Thanks to its I-SPEC clamp, installation is quick and does not require removing the grips. It also allows for a customized cockpit setup with a 20° adjustment angle for the shifter lever. The J-KIT system enables easy hose length adjustment before securing it to the master cylinder and/or simplifies internal cable routing.

SPECIFICATIONS

• Brake Type : Hydraulic disc brake
• Lever : BL-M7100 / Right-side / I-SPEC clamp / 2-finger design
• Caliper : BR-M7100 / Postmount / 2 pistons
• Hose : SM-BH90 - 1700mm
• J-KIT : Yes (hose is not pre-connected)
• Oil Type : Mineral
• Weight : 309g

BRAKE INSTALLATION

• - Position the brake lever on the handlebar.
• - Mount the caliper on the disc brake mount.
• - Remove the black rubber cap from the end of the hose.
• - Remove the plugs located at the end of the brake levers.
• - Slide the black rubber nut cover onto the hose.
• - Do not remove the small seal located at the end of the hose.
• - Insert the brake hose into the lever nut.
• - While ensuring the hose is fully seated in the lever nut, tighten the nut to compress the olive within the lever. Do not overtighten; the nut threading should remain visible, as it will later be covered by the rubber nut cover you slid onto the hose earlier.
• - Finally, activate the brake lever to complete the installation.